SE3 3 BAND EQUALIZER
SE3 features a pre-wired
balance control and master volume, Bass and treble on separate potentiometers
with the mid band control on SMT PCB. Each control pots are
designed to connect to PCB by connectors, which make SE3 installation
easier. All you have to do is solder connection to pickup, output
jack, ground and battery clip. High Impedance Input design matches
with any Active and Passive Pickup. And also Low Impedance Output
will keep the same tone from your guitar to any amplifier system
without losing high frequency response. Using advanced Surface
Mount Technology could reduce unwanted sounds (Noise) while increasing
sound quality and it's reliability. ARTEC guarantees a virtually
noiseless sound with long 9 V battery life. (more than 2000 hours in continuous use.
- workable voltage : drop down to 2.2 V). SE3-A features SE3 with a Concentric Potentiometer,
which is Bass and Treble bands are on one pot and mounted on SMT
PCB.
Application : Electric Basses, Electric guitars
& Piezo pickup equipped instruments. Technical
Specifications : Bass
: +/-12 dB at 80 Hz, Middle : +/-12 dB at 800 Hz Treble
: +/-12 dB at 4 kHz, Balance : MN500K
Potentiometer Current : 0.32 mA Voltage range : 6
V ~ 22 V Battery : 9 V Alkaline |